Peugeot 308 Key Fob Replacement

Peugeot's 308 might be getting on a bit, but it still feels appealing. It might not be the most luxurious car in its class It's the Ford Focus or Volkswagen Golf will isolate you even better from road imperfections, but it's still a pleasant and a civilized driving experience.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is ongoing or continuous the following tips will assist.

Water Damage

If you accidentally drop your key fob in a puddle, or if it gets wet while kayaking, canoeing, rafting, or canyoning the fob is more likely to be damaged by water. Keep your key fob in a dry, dry bag each time you are outdoors or engage in activities that could expose it to large amounts of water.

You should also ensure that the fob is dry before opening it up and reusing it. If you notice any odors emanating from the fob like an industrial liquid smell or windshield washer fluid, it's another sign that it's submerged in water.

A wet circuit could cause the battery's energy to drain or even explode. If you're able to fish the 308 key fob of whatever body of water it got stuck in then flip the button side down and shake out as much water as you can before opening the case. After opening it, remove the battery, and then clean the circuit board using an alcohol-soaked cotton swab. 90-percent isopropyl alcohol.

Other reasons your Peugeot 308 remote keyless entry system may stop working include an empty coin battery or receiver module issue signal interference, an electronic chip that is defective. If none of these is the reason, you may try resetting the system by disconnection of the battery at 12 volts for around 15 minutes.

Dead Coin Battery

Peugeot cars come with a remote-start system that allows the driver to start the car from a distance and then warm up or cool down the vehicle prior to entering. This feature is very beneficial especially during the cold winter months. The remote start system can stop working for a variety reasons, including the battery being dead.

A coin-shaped battery that is in the key fob has a life span of two to four years, based on how often utilized and where it was purchased. The date of use will be printed on the package or marked in the user manual.

If peugeot remote key replacement is no longer working after exposure to clean tapwater, remove the battery and clean the electronic chip with an absorbent paper towel that has been soaked in isopropyl ethanol. Then dry the chip completely before replacing. If the key fob was exposed to soapy or salty water, it could have caused the chip to be damaged. It is recommended to replace it.

If you're not sure whether the battery is defective You can test its voltage with an instrument connected to the terminals plus and minus. If the voltage is less than 12-13 volts, then you need to replace the battery. You can also reset the computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should begin to run after this.


Faulty Receiver Module

If you're not getting the "Key Detected" message on your dashboard, then it's possible that the receiver module has been afflicted with a fault. It's the component that sends out the signal when your key fob goes off. It also acts as an alarm that stops the car from starting if it doesn't have the correct key.

This can be due to various reasons, such as water damage or just aging. If your Peugeot 308 key fob has been exposed to dirty tap water, for example, the electronic chip on the inside will be damaged. In this instance, you'll have to take it off and thoroughly clean it using isopropyl or an electronic cleaner. When the battery is clean you can attempt to test it again.

If the issue is not resolved, it is a good idea to see a local Peugeot expert or locksmith. They can utilize an instrument for diagnosing to pinpoint the problem and repair it.

The loss of your Peugeot car keys could be an incredibly stressful experience. A reputable auto locksmith can solve the issue in a matter of minutes. They can program your vehicle and cut a fresh, functioning key for you. Click here to locate the nearest locksmith.

Faulty Electronic Chip

The electronic chip inside the Peugeot 308 key fob plays an essential role in the remote control system. If it is damaged your car may not start or receive a message saying "anti-theft active". If this occurs, the only option to fix the problem is to obtain a new key. Fortunately, professional auto locksmiths can provide the service in the shortest amount of time.

The chip inside your Peugeot 308's key fob could be damaged due to different reasons, including sweat, water damage or dirt. If your Peugeot key fob has been exposed dirty or soapy water, it should be cleaned as soon as possible. You can clean the electronic component with the help of a towel that is soaked in isopropyl Alcohol. The battery must then be allowed to fully dry.

Radio interference can cause the key fob to stop functioning. This could be caused by other devices that operate at the same frequency as your Peugeot key fob. It could also be caused by weather conditions or objects around the vehicle. It is recommended to visit a Peugeot dealer in the event of this issue.

The Peugeot Key Fob 207/308 is very delicate and requires special care. You should not drop it or throw it around. If you lose it, try to locate it as soon as you can. You can reset the onboard computer by disconnecting the battery for a few minutes. Make sure you disconnect the negative first, and then the positive.